Electric toys

Product definition

Electric toys are considered to be toys when designed or intended, whether or not exclusively, for use in play by children under 14 years of age. Electric toys may include construction sets, experimental sets and computer toys. Electric toys may take power from different sources including inter alia batteries, transformers, solar cells and inductive connections. The nominal supply voltage shall not exceed 24 V in any case.

The factsheet also covers remote controlled toys that use an optical communication channel (e.g. infrared remote control). Please refer to the factsheet on radio controlled toys if the toy employs radio communication for the remote control (Bluetooth, Wi-Fi, dedicated radio frequencies or other means of radio communication),

Common risks of electric toys

The most common risks identified in this product sector are set out below.

1. Electrical risks:

Live parts can cause electric shock.
Non-visible radiation can cause electromagnetic disturbance, such as interference with medical devices.

2. Risks from batteries:

Accessible small batteries (AAA or smaller) can be put in the mouth and swallowed, causing choking and damage to the gastrointestinal tract.
Short-circuits in the internal wiring or electronics can cause overheating of batteries or explosion, leading to leakage of dangerous chemicals.

3. Optical risks:

High-intensity light (e.g. lasers, LEDs and blue light) can cause damage to sight.

4. Thermal risks:

Hot surfaces can cause burns.
Poorly insulated or fixed wires or substandard components can short circuit and create arcs or overheating, leading to fire
Poorly constructed battery packs can overheat and experience thermal runaway, leading to fire or explosion.

5. Mechanical/physical risks:

Small parts can cause choking in children under the age of 36 months.
Sharp edges and points can cause cuts, bruising and other injuries.
High sound pressure levels can cause temporary or permanent damage to hearing.

6. Chemical risks:

Dangerous chemicals can cause short- and long- term adverse health effects if they exceed allowed limits.

This is a list of examples of common risks. However, the manufacturer has to carry out an assessment of the toy that covers all relevant risks that may be associated with the product and actions taken to mitigate these risks where possible. A general definition of risk and its relationship to hazards can be found in the factsheet on Risk management.

Examples of dangerous products

Specific examples of measures taken against dangerous electric toys offered for sale in the European Union are available on the Safety Gate website. Type ‘electric toys’ into the free text search box (but without the quotation marks) and select the ‘Toys’ Product Category to view notified examples. Further examples of dangerous electric toys are provided in the EU coordinated activity on electric toys A better understanding of mistakes made in the safety assessment of the toy or its manufacture can help avoid their repetition.

Main applicable legislation

These products are governed mainly by the Toy Safety Directive (2009/48/EC) (also available in Chinese). The Directive lays down the safety criteria that all toys must meet before they can be marketed in the EU. Toys must comply with the essential safety requirements set out in this Directive. More specific details can be found here.

Toy Safety Directive explanatory guidance document (also available in Chinese)
Toy safety guidance documents
Specific guidance on electric toys

In addition, if the toy is capable to communicate wirelessly, (e.g. incorporates Bluetooth or Wi-Fi, it should meet the requirements of the Radio Equipment Directive (2014/53/EU).

Please also check the factsheet for Power Supplies, Chargers and Adaptors for safety requirements for the external power supply (if applicable).

NB: For toys, certificates are only recommended, as well as involving a third-party laboratory in the conformity assessment excluding exceptional cases (if the manufacturer doesn’t follow the harmonised standards).

Applicable standards

“Harmonised standards” exist in the EU for toys. A toy complying with these standards is presumed to be in conformity with the essential safety requirements set out in the Toy Safety Directive if the standards are referenced in the Official Journal of the European Union (OJEU). Further information on, and the list of harmonised standards for toys is available from here.

Note: The site of CEN (the European standardisation organisation) provides links to the national standardisation bodies’ websites. In addition, the China Standards Information Services Network can be used to access European standards.

The following standards apply to electric toys:

EN71 Toys

The standard has been published in 14 parts. The most relevant parts for electric toys are:

EN 71-1: 2014+A1:2018. Mechanical and physical properties
EN 71-2: 2020. Flammability
EN 71-3: 2019+A1:2021. Specification for migration of certain elements
EN 71-9: 2005+A1:2007. Organic chemical compounds – Requirement
EN 71-10: 2005. Organic chemical compounds – Sample preparation and extraction
EN 71-11: 2005. Organic chemical compounds – Methods of analysis

EN IEC 62115:2020 including A11:2020 Electric toys

This standard applies to electric toys, i.e. toys having at least one function dependant on electricity. The standard covers the safety of electric toys in relation to their electrical function. It reduces risks when playing with electric toys, especially those risks that are not evident to users. Key parts of the standard are:

Small Batteries
Battery Compartment Fasteners
Requirements for the safety of light emitting toys (especially LEDs)
Requirements for the safety of remote-controlled ride on toys.
Clearance and creepage distances to address electric shock and fire risks

However, both standards cover other safety issues and manufacturers are strongly advised to consult all parts. It is important to note that the latest edition of the standard referenced in the OJEU (including any amendments) should be applied.

The toy is intended for children under 36 months

Small parts in toys

Toys indented for use by children under 36 months as well as their component parts and any of their detachable parts must be of such dimensions as to prevent their being swallowed or inhaled.

If the toy (or separate part) fits completely into the small parts cylinder – defined in standard EN 71-1: Mechanical and physical properties – it will be defined as a small part and will therefore fail to meet this requirement of the Toy Safety Directive.

Specific limits for chemicals

Toys intended for children under 36 months need to respect stricter limit values for certain chemicals, as listed in Appendix C to Annex II to the Toy Safety Directive. In addition, specific migration limits for nitrosamines and nitrosatable substances are set out for these two categories of toys in Annex II Part 3 Point 8 of the Directive.

Hygiene

Toys intended for use by children under 36 months must be designed and manufactured in such a way that they can be cleaned. Textile toys should be washable, except if they contain mechanisms that may be damaged if soak washed (in which case there should be a possibility for a surface cleaning). The toy shall fulfil the safety requirements also after having been cleaned.

See related requirements

Guidance document on the criteria for age classification of toys

Other legislation of relevance:

While manufacturer’s need to familiarise themselves with all the laws which apply to their specific products, the following summarises some further key applicable laws:

The REACH regulation restricts chemical substances in goods. REACH stands for “Registration, Evaluation, Authorisation and Restriction of Chemicals”, and it places responsibility on the industry to manage the risks from chemicals and to provide safety information on the substances. The European Chemicals Agency (ECHA) maintains a list of substances of very high concern (the “SVHC list”). According to article 56(1) of the Regulation, manufacturers shall not place products containing any of the substances on this list on the market. The updated list of substances of very high concern can be found on ECHA’s website.
EMC (Electromagnetic Compatibility) – lays down requirements for emission of electromagnetic disturbances to the environment and immunity to electromagnetic disturbances in the surrounding environment. Electromagnetic immunity and disturbances for products incorporating a communications device are dealt with under the Radio Equipment Directive.
RoHS 2 Directive (Restriction of Hazardous Substances) – restricts the use of certain substances and chemicals in electrical and electronic equipment
WEEE (Waste Electrical and Electronic Equipment) – establishes rules for treating of waste electrical and electronic equipment, to contribute to sustainable production and consumption

Please note that every product must be safe for the consumers. If a particular safety aspect of a toy is not covered by the Toys Safety Directive regulation, then the General Product Safety Regulation (GPSR) applies.

Mandatory labelling & warnings

The following are obligatory:

CE Marking is obligatory for all toys. Before marking the toy with the CE mark, the manufacturer needs to carry out a safety assessment on the toy and identify all the applicable essential safety requirements, verify the conformity of the toy with these requirements, compile a technical documentation that evidences this and create a written declaration of conformity. When this has been done, he should affix the CE mark on the product. Refer to the factsheet on CE marking.
Information on the manufacturer and the importer in the EU is obligatory.
The crossed-out wheel bin is obligatory for all electric toys to indicate that they must be disposed of according to the rules for handling of waste from electronic and electrical equipment.

Warnings and instructions for use need to draw attention of users and supervisors to the inherent hazards and associated risks and how to avoid injury.

Safety warnings are obligatory for many types of toys including electric toys. For example, toys not suitable for children under 3 years old must include a warning stating “Not suitable for children under 36 months” or “Not suitable for children under three years” or a warning in the form of the graphic below. The warning shall be accompanied by a brief indication, which may appear in the instructions for use, of the specific hazard calling for this precaution.

Attention! This warning should be used only in circumstances where the toy is genuinely NOT intended for children under 3 years old and does not exempt manufacturers from complying with specific additional requirements imposed on these types of toys.

General safety requirements

To ensure safety of electric toys, there is also a range of general requirements to be fulfilled. These are explained in the following factsheets and need to be read in conjunction with this factsheet:

You may also visit the SPEAC ACADEMY to learn more about the EU Safety requirements.

Disclaimer

The provided information was updated in 2025. Please note that some of the provided information could change during possible subsequent revisions of legislation, standards, and guidance documents. For any updates of official information on the EU product safety rules, please follow the Link to the webpage of the European Commission.

This document was produced with the financial support of the European Union. Its contents are the sole responsibility of SPEAC project and do not necessarily reflect the views of the European Union.